26 LED REAR BUMPER MARKER/BRAKE LIGHT INSTALL INSTRUCTIONS
Installation is as simple as gaining access to the rear of your bumper, popping out the factory reflector and inserting your new LED bulb. You must then tap into your factory tail light wiring to power the LED lamps. Soldering is the best method to attach the wires and that's what we recommend but you may also use wire taps to tap into the wiring of you're unable to solder.Â
Â
 Wiring as additional brake lightsÂ
Black wire -> Black wire at factory tail lamp
Red wire -> Brown wire at factory tail lamp
White wire -> Black/white stripe at factory tail lamp
Â
Wiring as additional signals
Black wire -> Black wire at factory tail lamp
Red wire -> White/red stripe on left tail lamp.  -> Grey on right tail lamp.Â
White wire -> Black/white stripe at factory tail lamp
Â
Â
Â