BRZ/FRS/GT86 WIRING INSTRUCTIONS

  • Install new lamp in place of factory lamp by removing 2 10mm bolts on the top and 2 retainers on either side of the lamp
  • Remove the factory harness and feed the provided new long harness into the trunk (ignore the short 2 wire harness. not required)
  • Use the provided main harness to plug into the factory plug in the trunk to power the reverse lights on your new lamp
  • Cut the blue wire from the main harness (see picture below) and tap it into the Light green factory wire in the trunk
  • tap the loose brown wire into the factory red wire in trunk
  • tap black wire into the black ground wire in the trunk.